Table of Contents
Introduction
Light Base is a light source that brings lights what you put on.Just press the switch button and place any item that you found during trips, or that is one of your favorite materials on the product.
You can place Light Base anywhere in your house, on tables, in bedrooms, and so on, which makes your nights a little more fancy.
Since the light source part does not generate heat, you can put anything, even materials that are sensitive to heat.
Fully charged battery works 150 hours with the [Soft] mode, 40 hours with the [Strong] mode, and 70 hours with the [Fluctuating] mode.
You do not worry about using too much battery, as the built-in timer automatically switches it off 8 hours after the last switch button touch.
How to use
Please remove the transparent sheet on the back side of your Light Base before use.The battery is somewhat charged, therefore you can start using it immediately.
Every time you press the switch button on the side of the product, the LED light mode changes as shown below.
The [Fluctuating] mode provides you with the light fluctuating like candles.
It automatically turns off 8 hours after the last button touch.
How to charge
If the product turns off before 8 hours after the last button touch, it means the battery is running out.Please charge the products by connecting to the power with USB cable (Type C: cable sold separately).
NOTE
While charging, the LED slowly flickers every 2 seconds, and turns off when the charging is over.- The charging does not start when the battery is full.
(The LED flashes twice) - The USB connector may be broken if you try to put the cable too strongly.
If you start charging from the empty battery, it takes you 4-6 hours to get it fully charged.
NOTE
- Unable to operate under power feeding from USB cable.
- Do not charge except the built-in batteries.
About batteries
The built-in rechargeable batteries can be charged approximately 1000 times.When the batteries are getting old, you can buy new Nickel-Metal Hybrid Batteries and replace them with the old ones.
You can open the lid on the back side with a screwdriver to open the battery box.
You can also replace them with alkaline AA battery AA batteries.
Cautions when using alkaline AA Batteries
- We do not guarantee the running time till the batteries run out.
- Remove used batteries when they are fully used for safety.
- If you do not, the liquid inside might come out and damage your Ligh Base
Caution
- Light Base is not waterproof, please do not put wet items on.
- Do not use the product outside. Also, avoid using or storing in humid spaces.
- The USB connector may be broken if you try to put the cable too strongly.
- Do not attempt to disassemble this product.
- If you do not use Light Base for a long time, store it with the batteries removed.
- Do not stare at the LED light, as it may damage your eyes.
- Do not charge batteries except for the built-in battery.